Education
Use a screwdriver to remove one of the two base screws underneath the plastic housing for the mirror. The mirrors are on both sides of the vehicle slightly front side window. Pull the finish around the edge of the wing mirror away from the vehicle. Gently slide the mirror base and keep it in a safe place for later reintegration. Be careful not to damage the mirror or picture when you remove it.
Raise wipers so they are at an angle of 90 degrees. Feel in the rear of the cleaner to find a plastic tab. Press the tab and slide the wiper of his metal frame. Removing wipers and mirrors will give optimum access to the windshield.
Cut the rubber seal around the windshield with a sharp knife. The rubber coating is black and around the edges of the windshield. Make an incision in the top frame and carefully cut the rest of the layer, working your way around the windshield to the right. You need to cut all the rubber away from the windshield. Remove the seal completely away from the windshield with his hand and throw it away.
Between the drivers’s seat of the vehicle and carefully push the windshield out and away from the chassis. Press from the center of the windshield to ensure pressure is not applied to the edges. While pushing outward windshield starts to break the frame. Having another person present to help support the weight of the windshield. Place a thin layer of windshield sealant around the edges of the windshield again. Attach a new seal at the bottom in the windscreen so that the heavy part is inside the groove and is on the outside. Align joints on the board so that they are in the bottom dead center of the windshield. Press the seam sealer on the windshield. Hold that position for several minutes to allow you to set in place.
Take a nylon rope around the outside groove to the edge of the windshield. With the help of his partner, lift the windscreen and place inside the frame. Comrade press the windshield down against the frame for a few minutes to allow the seal is in place. Insert the vehicle and pull the nylon cord through the windshield, so that goes through the top of the instrument panel at the point where the windshield and dashboard cross. This will allow the rubber lip to set in place that will help ensure the windshield. Clean the windshield and the dashboard to prevent debris from entering the openings of the vehicle.