Things will need:

• Goldwing windshield replacement
• Wrench
• Flathead screwdriver
• Cleaning shop towels
• Allen key set

Instructions

1. Buy a new windshield to adjust the corresponding model of your motorcycle Honda Goldwing.
2. Begin removing the old windshield Goldwing by locating and lifting height levers. Rubber boots should be thrown into the Goldwing mirrors.
3. Move your bike forward mirrors to locate a 10mm nut on the lever of the windshield height Goldwing. To prevent loss of the nut, squeezing a cloth under the nut before removal. Use a wrench to remove the nut. A magnet can be used to collect the nut if necessary.
4. Place a cloth on a flat screwdriver to avoid damaging the windscreen Goldwing garrison. Slide the screwdriver under the windscreen cover Goldwing garrison. Gently pry out the lining and pop the heads of rings.
5. Finish removing the windshield Goldwing by lifting lining like the hood of a car. Turn the covered part of about 180 degrees.
6. Look for the last bolt 8 mm and remove, taking care not to lose inside the bike. The garrison Goldwing windshield should easily lift off by your bike.
7. Remove the remaining screws and carefully remove Goldwing windshield age.
8. Use the Velcro strip on the board, as indicated. Start on one side and press firmly to ensure that the Velcro is glued in place. Velcro ends the application by trimming to fit your board.
9. Adapt to their new windshield Goldwing on his bicycle. Replace the windshield, following the removal instructions in reverse.